The belt conveyor in the customized three cylinder dryer should be repaired in all aspects every six months, except for maintaining normal operation and dismantling some damaged parts throughout the entire application process. During maintenance, try to eliminate any shortcomings in application and narrative, dismantle damaged parts and grease, etc. The company can establish maintenance cycle times based on the working standards for customized three cylinder dryers. Before the operation of the mesh belt conveyor, it is necessary to establish that the equipment, workers, and transported objects of the mesh belt conveyor are in complete and safe condition; Next, check that all fitness exercise positions are functioning properly, and verify that all electrical equipment and routes are functioning properly. Only when everything is normal can the belt conveyor be used for fund management and operation. The final requirement is to check that the difference between the working voltage of the power supply system and the rated current of the equipment should not exceed ± 5%.

When the drying net is found to be damaged or severely damaged, the conveyor belt should be repaired or disassembled immediately. The method of disassembling and assembling the drying net is as follows: first, remove the chain sprocket at the transmission end of the main gear of the drying net layer, and the staff's house faces the equipment. On the left side of the equipment, unscrew the anchor bolts on the bearing end cover of the passive rolling bearing of the drying net layer. Then, open the inspection door and remove the protective cover of the transmission chain of the drying net transmission device. When replacing the new drying net, pay attention to twisting and tightening the drying net and the supporting net roller with stainless steel wire at a distance of 6-8 between each distance. Install and adjust according to the reverse process described. Attention: When adjusting the tension and looseness of the transmission chain of the drying net transmission device with the adjustable distance seat located on both sides of the passive shaft, the transmission chain of the transmission device transmission system should not be loose or loose, and the tension and looseness of the transmission chain of the upper and lower transmission devices should be kept as consistent as possible.