Introduction:The hydraulic servo test system platform is a new type of flat platform and one of our manufacturer's flagship products. The hydraulic servo test system platform is a product specifically used in the automotive inspection and testing industry. In terms of quality, we fully guarantee fine workmanship, excellent quality, and accurate precision.

The hydraulic servo test system platform may experience weight deviation during the production process. The design of hydraulic servo test system platforms often takes into account casting errors and mechanical processing errors, and the weight error of the test platform should generally not exceedWhen it exceeds 10%, further evaluation of the quality of the cast iron test platform is required to determine whether the cast iron platform can be put into use.

The hydraulic servo test system platform adopts a manual scraping process. Although manual scraping and grinding are relatively backward, for experimental platforms, it is a processing technique that cannot be replaced by any mechanical processing when high precision is required. In order to improve the service life of the experimental platform and ensure its working accuracy, it is recommended to control the scraping depth withinAbove 0.02mm, this can ensure a longer service life and calibration cycle.

According to relevant information on the introduction of scraping depth and the data obtained from scraping depth measurement, the processing requirements of this process can be achieved. There are vibration marks on the appearance, and the surface roughness of the product increases, which affects accuracy and aesthetics. After the scraping and grinding process, the above problems rarely occur. To prevent small local distortions on the working surface and ensure the accuracy of the experimental platform. Check the micro quality of the surface, that is, the flatness of small peaks and valleys. High surface micro quality and good wear resistance are necessary to ensure the service life of the test platform.

Common specifications for hydraulic servo test system platform:

1000×1000mm ; 1500×1000 mm; 2000×1000 mm; 2000×1500 mm; 3000×1500 mm; 3000×2000 mm; 4000×2000 mm; 4000×2500 mm; 4000×3000 mm; 5000×2000 mm; 5000×2500 mm; 5000×3000 mm; 6000×2000 mm; 6000×2500 mm; 6000×3000 mm; 8000×3000 mm；

Advantages of hydraulic servo test system platform in the process:

1. Moisture resistance, corrosion resistance, no need to apply oil, no rust, and no fading.

2. The temperature coefficient is the lowest and is basically unaffected by temperature.

3. It requires almost no maintenance, can be quickly and easily cleaned/wiped, and has good accuracy and stability.

4. It is always the hardest surface.

5. Smooth "bearing" surface, free from dirt, wear-resistant, and non-magnetic.