Using the principle of gear pump, the measurement and speed are controlled by a microcomputer to fill the liquid into a straight container with accurate measurement, suitable for various liquids
The loading capacity, speed, and filling interval can all be set on the control panel

The first filling can be set as fast first and then slow to eliminate the foam generated during filling

The control panel is sealed and waterproof. Simply touch the button to set parameters, and the LCD screen can monitor production parameters and operating status in real time

20 sets of product parameters can be preset for easy adjustment of filling specifications and quantities at any time

The pump body is exquisitely designed without the need for tools, easy to disassemble, and easy to clean

Can be connected to a conveyor and can be used with up to 4 filling machines per conveyor belt

1. A new type of filling equipment that uses high-precision micro magnetic pumps, pump speed, and pump working time to measure filling volume. The pump head is made of 316L and is resistant to acid, alkali, and corrosion;

2. Widely applicable, almost all flowable liquids can be filled, especially suitable for filling oils, detergents, acidic and alkaline liquids, and highly corrosive liquids.

3. Its structure is simple and easy to operate. And the discharge nozzle can be extended, and the leather tube can be moved freely for filling, which can meet the filling capacity requirements of 5ml-2000ml without being limited by the filling capacity. It is a reliable and durable filling equipment.

4. The pump head and motor are imported from Japan, and the time regulator is made of the international brand Omron. Other components are produced by well-known domestic manufacturers, with stable and reliable performance and long service life;

5. The magnetic pump head is driven by magnetic force, and there is no shaft connection between the pump head and the motor. There is no need to worry about damage to the shaft seal, splashing, or excessive load on the pump, which may burn out the motor; Using a frequency converter to start and brake, adjusting the motor speed with a potentiometer, and filling time accurate to 0.01 seconds to ensure filling accuracy with an error of less than 2%;

The generation of filling errors is mainly determined by the filling volume, filling speed, and the opening and closing speed of the upper and lower valves. The opening and closing speed of the upper and lower valves is related to the viscosity of the product. The higher the viscosity, the slower the valve opening and closing speed.

2. Adjust the opening and closing speed of the valve mainly by adjusting the spring pressure of the switch As the spring pressure increases, the opening and closing speed of the valve accelerates.

3. The adjustment of the spring pressure of the valve should be determined through trial filling measurement and the experience of the operator.

The liquid filling machine is only suitable for filling low concentration items such as liquids and cannot be used for other purposes. To ensure safe production, please pay attention to the following:

1. Use power and gas sources that comply with the regulations for liquid filling machines.

2. Before disassembling and washing the liquid filling machine, please make sure to turn off the air source and power.

3. The rear half of the liquid filling machine (near the control button) is equipped with electrical control components inside. Under no circumstances should you rinse the machine body directly with water, otherwise there is a risk of electric shock and damage to the electrical control components

4. To prevent electric shock, the machine should have a good grounding. Please provide a grounded power socket for the liquid filling machine.

5. After turning off the power switch, some circuits in the electrical control of the liquid filling machine still have voltage. When repairing the control circuit, be sure to unplug the power cord.