VIP member
Product details
plastic mill
Main technical parameters:
1. Number of disc cutters: 1, outer diameter: 493mm ± 1mm
2. Gear plate: 1 set of 12 pieces (high-quality alloy steel, hardness 55o-58 o)
3. Blade: 24 pieces (high-quality alloy steel, hardness 52 o-55 o)
4. Main motor speed: 2950r/min
5. Main motor power: 37KW, equipped with V-belt, type A, 2184mm, a total of 6 pieces.
6. Induced draft fan: equipped with a 3KW electric motor
7. Turn off the fan: equipped with an electric motor of 0.75KW, 2.8L
8. Production capacity: around 250kg/h for 20-80 mesh
9. Dimensions: Complete set of machine (length x width x height) 1900 x 1500 x 3900
Working principle
The working part of the PVC plastic grinding machine is the cutterhead. High speed particles are partially crushed after colliding with the toothed plate and are extracted by suction, while larger particles continue to collide and are extracted after being crushed. This reduces the load on the cutterhead, improves the grinding efficiency, and ensures even cooling of the powder.
Low temperature is the main advantage of PVC plastic grinding machine. According to thermal work equivalent: converted into 860 kcal of heat per hour of work. This machine is equipped with external ventilation. The air volume reaches 50m/KW, and most of the heat is taken away by the temperature difference between the inlet and outlet air. A small amount of heat is solved by water cooling. The inlet temperature of cold water should not exceed 25 ℃, and the outlet water temperature should not exceed 45 ℃. In summer, the cooling water flow should be increased appropriately to reduce the temperature.
Maintenance and upkeep of the grinding machine:
1： When starting, the machine must be used empty (the host must not have any materials and must be started empty, otherwise the motor is prone to burning), and it should be cleaned up in a timely manner before starting during commuting.
2： When there is no material in the hopper after work, it should idle for 5-10 minutes.
3： Clean the dust every day. The automatic grinding machine has an automatic dust cleaning function button, while manual cleaning is required
4： Bearing lubrication. (1. The rotor has oil holes, which need to be oiled once a day within ten days of the new machine. It can withstand high temperatures of 300 degrees and needs to be fully oiled once. After ten days, it can be oiled once every 7-10 days. 2. The outer holes need to be oiled daily.)
5： Adjust the tightness of the belt every day.
6： This machine is water-cooled, and the inlet water temperature cannot exceed 30 degrees.
7： When the machine vibrates, it is necessary to perform balance calibration in a timely manner.
8： If the internal cutting tools of the host are broken and replaced with new ones, they should be balanced and calibrated in a timely manner.
Online inquiry
-
Contacts
-
Company
-
Telephone
-
Email
-
WeChat
-
Verification Code
-
Message Content
-