Rotor 0The ultra-low viscosity adapter is an optional accessory, and the usage method is as follows:

1. For liquids below 15mpa. s, use rotor 0 without a protective frame. Install rotor 0 on the connecting screw (rotate counterclockwise to install).

2. Insert the fixed sleeve into the lower cylinder of the instrument and tighten it with the sleeve fixing screw.

3. Pour 20-25 milliliters of the tested liquid into the outer test tube (with a bottom).

4. Insert the outer test tube into the fixed sleeve and tighten it with the test tube fixing screw. When tightening, pay attention to the tapered end of the test tube fixing screw to screw into the triangular groove at the upper end of the outer test tube (you can observe whether the triangular groove of the test tube is located at the center of the circular hole on the side). After controlling the temperature of the tested liquid, the test can be carried out.

When using a bottomless outer test tube, the method is basically the same as above (except for 3). When the outer test tube and rotor are immersed in the groove ring of the outer test tube as the liquid level line.