Introduction:Safety component testing laboratory platform, testing platform, motor testing platform, T-slot platform - Quanyi is a professional manufacturer of safety component testing laboratory platforms. Our manufacturer can provide customized products. You can send us the drawings, and after careful research, we will immediately proceed with the production.

The safety parts laboratory is mainly responsible for the national mandatory inspection of non-metallic products, such as safety belt anchorage, steering mechanism, anti-theft device, safety belt, seat, seat headrest, external projection, door lock, door hinge, sliding door, rear-view mirror, plastic fuel tank, brake hose, interior materials flame retardant, plastic and rubber parts, as well as some routine tests, including high and low temperature tests of non-metallic materials, xenon lamp aging tests, ozone aging tests, salt spray tests of various metal parts, as well as tests of steering wheel, instrument panel, sun visor, sealing strip, air conditioning pipe, foam material, high-pressure fuel pipe, seat fabric, rubber products, plastic and other non-metallic products.

The safety component laboratory platform, also known as the safety component motor experimental platform or cast iron platform, is generally used as a reference positioning surface in calibration or precision testing. The experimental platform is suitable for testing the surface flatness of workpieces using the coloring method, or as an auxiliary tool for experimental work. Each center of the cast iron platform working face is subjected toUnder a load of 250N, the deflection of the safety component laboratory platform should not exceed 1m. During the experiment, the deflection value of each level of flat plate should not exceed half of the flatness tolerance value of the 00 level flat plate. The specific indicators of the rated load and allowable deflection values applied to various specifications of experimental platforms in the concentrated load area in the center of the working face are shown in the table below.

Precision testing standard for safety component testing laboratory platformAccording to the national standard metrological verification regulations, there are four levels: 0, 1, 2, and 3 Surface quality and color testing of flat panels The tablet specifications are not fully listed, please inspect according to approximate size requirements Grade 0 and Grade 1 flat plates shall have no less than 25 points on each side within a range of 25mm square; Grade 2 flat plates shall have no less than 20 points on each side within a range of 25mm square; Grade 3 flat plates shall have no less than 12 points on each side within a range of 25mm square.

The safety component laboratory platform adopts a manual scraping process. Although manual scraping and grinding are relatively backward, for experimental platforms, it is a processing technique that cannot be replaced by any mechanical processing when high precision is required. In order to improve the service life of the experimental platform and ensure its working accuracy, it is recommended to control the scraping depth withinAbove 0.02mm, this can ensure a longer service life and calibration cycle.