OneOverview

The DDSY1791 electronic single-phase prepaid energy meter adopts the most advanced application specific integrated circuit design and is manufactured using fully automatic surface mount (SMT) production technology. The circuit design and component selection of the electric energy meter are based on a large environmental tolerance, which can ensure long-term stable operation of the whole machine, high precision, high overload, low power consumption, and high reliability performance. Adopting advanced intelligent IC card technology that meets international standards to achieve prepaid payment, with built-in magnetic holding relay. By controlling the relay to control the on and off of the load, the function of urging users to buy electricity before using it can be achieved.

The product meets all technical requirements of GB/T17215.321-2008 "Level 1 and Level 2 Static AC Active Energy Meters" and GB/T 18460.3-2001 "IC Card Prepaid Electricity Sales System Part 3: Prepaid Energy Meters".

2、 Working principle

1Working principle diagram

The electric energy meter obtains voltage sampling signals from the voltage divider, current sampling signals from the current divider, voltage current product signals from the multiplier, and then generates a counting pulse proportional to the product of voltage and current through frequency conversion. Through frequency division, it drives the stepper motor to measure electricity.

2Data processing

The electric energy metering pulse is sent to the CPU through a photoelectric coupler for processing, and after calculation, it is stored in the memory. The information system is managed by a computer, and through an IC card reader/writer, a certain amount of electricity and monitoring requirements are written into the IC card input table of the microprocessor system. After being processed by the CPU, it provides display and alarm status signals.

3、 Specifications, models, and technical parameters:

1. Specification and model

2. Main technical parameters:

a、 Basic error:

b、 Electrical parameters (reference conditions):

Starting current: 0.4 % Ib

Power consumption: Voltage line<1.0W, 3.0VA;

Current line<1.0VA

Stealth: equipped with logic anti creep circuit

Voltage range: 220V ± 10%

Working temperature range:- 25℃~ +55℃

Power failure data storage time>20 years

4、 Installation and use

1. The electricity meter has been inspected and qualified before leaving the factory, and sealed with a lead seal before installation and use. If there is no lead seal or it has been stored for too long, relevant departments should be asked to re verify and seal it before installation and use.

2. The electric meter should be installed in a dry and ventilated place, and the bottom plate for installing the electric meter should be fixed on a sturdy, fire-resistant, and vibration resistant wall. The height of the electric meter is about 1.8 meters.

3. Install and wire according to Figure 1 and Figure 2, tighten the wiring screws, and secure the connecting plate inside the terminal box.

4. The reading of an electric meter connected through a transformer must be multiplied by the transformation ratio to obtain the actual amount of electrical energy.

5. One table, one card: The IC card held by the user cannot be exchanged. In case of loss, a replacement card should be purchased from the power supply department (sales office).

6. Preparation for purchasing electricity: Before purchasing electricity, the user must insert the IC card into the card slot once to facilitate sending the data in the meter back to the computer database.